HST Series Accessories

FEATURES:

• The heavy duty coiled power extension cable is designed to provide extended power cable length when using an HST Stand Alone Power supply.
• Allows for providing power to HST heat detector tester at distances of up to 20 feet away from the stand alone power supply.
• Retracted Length: approx. 48" (1.2m)
• Working length: approx. 20' (6m)
• Rubber strap at male connector end fastens to inspection pole to prevent the weight of the cable from pulling on connectors and prevents cable from falling should it become disconnected while in use. Do not use if rubber strap is not in place and properly fastened.

MATERIALS:

• The cable is 2 conductor, 300volt, 0.25” diameter – coil O.D. is 0.85"
• The cable connectors 250 volt, IP40 connector, bayonet locking, PA and PBT plastic

ELECTRICAL / MECHANICAL:

• Durability – minimum 300 cycles without mechanical or electrical failure
• Voltage – Maximum 24vdc @ 10.0 amps
• Weight: 0.95 lbs
• Voltage/Connector configurations:

Model HSTEXT148, 14 volt, 2 pin connector
Model HSTEXT185, 18 volt, 4 pin connector
Model HSTEXT259, 24 volt, 3 pin connector

ENVIRONMENTAL:

• Temperature-  -40°C to +85°C (-40°F to +185°F)

When using with extension poles, the cable must be fastened to the inspection pole using the rubber strap provided. The purpose of this is to provide strain relief on the connectors and to prevent the cable from falling on the user should the connection to the HST become disconnected. Make sure that cable does not touch hot surface, moving equipment, or any other dangerous surface.
See following picture for clarification on proper attachment.

Picture 1: Fasten the axial cable lead to the pole using the rubber strap provided.

DO NOT USE CABLE WITHOUT SECURING CABLE TO POLE USING RUBBER STRAP